How do I set up my new BLD PC?

Have more questions? Submit a request

Congratulations on your purchase of an NZXT custom BLD PC! Now that you have your new PC, it's time to get the system setup. Follow these steps so you can get to gaming in no time:

Unpacking your PC

Firstly, before you open your packaging, make sure that the box is facing the correct side up, there will be helpful symbols on your box that will indicate which side is up on the box. Now you can cut open the packaging tape to get inside of your system. When opening the packaging you will find the following items inside:

  • Your PC.
  • An accessory bag with extra items that were included with your original components.
  • Any optional peripherals you purchased with your system (Monitors are shipped in separate boxes.)

After removing your PC from the box you will notice a white bag inside the case. This bag is called an Instapak and it is placed inside your PC to help prevent damage during shipping. To remove the Instapak you will need to carefully remove the glass panel by loosening the thumbscrew located at the top left of the glass panel. Below is an example with our H710 case, which also shares the same screw location as the H510 and H210.

Screw.jpg

Getting your PC fully hooked up

Now that the Instapak has been removed you can now hook up the power cable. The power cable will connect to the port on your power supply show in the photo below.

PC.jpg

Next, you will attach the Display cables to the GPU (aka the graphics or video card). The GPU is the horizontal slot about halfway down the back of the PC as shown in the example below. You will need to use either a DisplayPort (left) or HDMI (right) cable to connect the system to your monitor. 

GPU.jpg

Now if you have purchased a system that is WiFi/Bluetooth Capable, you will also need to connect the included wireless antenna. Unlike phones or laptops, most gaming PCs need an external antenna to be connected in order to use WiFi or Bluetooth. Without these antennas, your PC may have poor reception for wireless connections or may not even be able to connect at all. You can find examples of these in the photo below.

Antennas.jpg

Once you have located your antenna(s), installation is easy, there will be two brass connectors on the PC that you will be able to screw onto the antenna(s). This is shown in the example below.

Anetnnassssssssss.jpg

Now that the PC has the power cable, display cable, and possibly antennas installed, you are now able to power on your PC. Make sure the switch next to your power cable is in the "I" position. (Pictured below in the "I" Position).

on_switchreeeeeeeeeeeee.png

Then on the top of the case, firmly press the power button (as pictured below.)

Power_buuuton.jpg

Your PC should now show signs of life: fans spinning, lights, and a display on your monitor! That means you are all clear to hook up your peripherals (keyboard, mouse, etc.) to your PC. You can also now attach your headset or speakers to the system in either the front or rear audio ports. Please note that in order for your headset to have both your headphones and microphone enabled you will need to either use a split headset with 2 inputs or a USB headset. Single jack headsets may work for one or the other, but may not work at all.

You are now free to set your region and complete your Windows 10 setup. After setup is complete you are all set to begin downloading games. Have fun!

If you have any questions or require assistance, please contact our Customer Support Team.

Articles in this section

Was this article helpful?
211 out of 292 found this helpful
Share

Comments

0 comments

Article is closed for comments.