H710 Cooling Compatibility

Our H-Series of cases come in a variety of form factors that are compatible with many combinations of our cooling products. This article will detail the compatibility of our cooling accessories within the H710.

Cooler Compatibility:

The NZXT H710 is compatible with the following coolers mounted to the front of the H710 (location pictured below):

• Kraken X2 Series
• Kraken X3 Series
• Kraken Z3 Series
• Kraken M Series

The NZXT H710 is compatible with the following coolers mounted to the top of the H710 (location pictured below):

• Kraken X2 Series
• Kraken X3 Series
• Kraken Z3 Series
• Kraken M Series

The NZXT H710 is compatible with the following coolers mounted to the rear of the H710 (location pictured below):

• Kraken X42
• Kraken M22

Potential Conflicts:

• Two 360mm Kraken coolers mounted in the top and front mounting locations, 3rd party coolers may not fit as it could be a tight fit.
• It is not possible to have a 140mm cooler mounted to the rear and a 360mm radiator mounted to the top. Due to the space available, there isn’t room. A 120mm radiator would need to be mounted to the rear instead.
• A 360mm radiator mounted to the front of the case will require the HDD tray to be moved over. Depending on the amount of space available in the PSU shroud you may have to remove the HDD tray.
• Two separate coolers cannot be mounted on the top or front. There is not enough clearance mounting two radiators separate on the same mounting rails.