The H9 Flow (2025) can support the following fan configurations:
F120X | F140X | F240X | F280X | F360X | |
| Front | 3 | 3 | 1 | 1 | 1 |
| Top | 3 | 3 | 1 | 1 | 1 |
| Bottom* | 3 | 3 | 1 | 1 | 1 |
| Rear | 1 | 0 | 0 | 0 | 0 |
* While using bottom mounted fans in the H9 (2025), performance fans may stand ~4 mm proud from the floor of the case.
How many fan controllers do I need?
If you are looking to control Performance Fans using NZXT CAM, the fans must be connected via an NZXT controller such as the Control Hub. For most configurations, only a single controller is necessary. Some example configurations are included below:
Control Hub + Kraken Elite/Kraken Plus 360 (2024)
This configuration will require minimal wiring or additional accessories, however it will be limited to 120 mm base fans (F120X and F360X) and radiators (Kraken Elite 360).
Fan Model | Controller Header(s) | |
| Front | F360X | NZXT 8-pin 1 (Control Hub) |
| Top (Kraken Elite 360) | F360X | NZXT 8-pin (Kraken Elite/Kraken Plus) |
| Bottom | F360X | NZXT 8-pin 2 (Control Hub) |
| Rear | F120X | Fan - 4-pin PWM Fan RGB - 4-pin NZXT RGB |
Control Hub + Kraken Elite 420
| Additional Accessories Required |
This configuration requires additional accessories not included with the NZXT Control Hub. Availability of accessories may be limited. NZXT Control Hub includes the following accessories:
|
Fan Model | Controller Header(s) | |
| Front | 3 x F140X |
|
| Top (Kraken Elite 360) | 3 x F140X |
|
| Bottom | 3 x F140X |
|
| Rear | F120X | Fan - 4-pin PWM Fan RGB - 4-pin NZXT RGB |
Comments
0 comments
Article is closed for comments.