In this article, we will detail the process of replacing your Smart Device V2. This can be done easily with a Phillips #1 Screw Driver and a bit of time. Firstly, you would need to remove the glass panel and the back panel on your H510 case. This can be done by loosening the screws shown in the photo below.
Once the panel is removed, you will need to remove the two screws holding the Smart Device to the case pictured below.
Once removed, the smart device will be free and from here you will need to disconnect the Smart Device from your motherboard and fans. The three leftmost connectors on the controller are the fan splitters, you can leave these connected to the fans and just disconnect the splitter from the controller itself. There will also be the RGB header on the right side of the controller, disconnect any cables hooked up to it. Then follow the remainder of the cables from the smart device to your motherboard/PSU and make note of where they are connected for re-installation. This is also shown in the diagram below.
After you have removed the Smart Device v2, reverse the previous steps to install the new module you received. If you have any questions on this process please contact our Customer Service Team.