In this article, we will detail the process of replacing your H710 USB Module. This can be done easily with a Phillips #1 Screw Driver and a bit of time. Firstly, the front and top panels will need to be removed, refer to the GIFs below on how to do this.
After these panels are removed, you will then need to remove the three screws located on the USB module shown below.
Once these three screws are removed, we recommend following all the cables from the hub to your motherboard to verify where they are connected. In the photo below are photos of these connections for your reference when searching for these cables. Note, for the USB 3.1 Gen 2 connector, some motherboards may not support this connection so if you cannot find it, verify your motherboard supports it.
After you have removed the H710 USB module, reverse the previous steps to install the new module you received. If you have any questions on this process please contact our Customer Service Team.